Periodic inspection of the leveler and load operation

If the stress of repeated deep drawing during the operation of the leveler is too large, it will directly lead to fatigue damage to its equipment. During the operation of the leveler, the repeated load-bearing places should be calculated, and the equipment will have high strength for a long time. Repeated stress will cause its cracks.

The stress-concentrated area of the leveler has a relatively large bending moment, mainly at the nut connecting the lower beam, the load and centrifugal force, the damage of the column of the equipment will not be suddenly broken by force, and it will take dozens of hours. Ten thousand times of repeated stress, and then cracks will occur.

After the straightening machine has been running for a period of time, it is necessary to regularly check whether the knobs and keys are damaged. Always maintain good ventilation.

After each year of operation of the leveler, it needs to release its hydraulic oil from the body tank to clean the tank, and then refill the filtered hydraulic oil. The amount of oil should be determined at about 3/4 of the oil level. More appropriate.

Straightening machines are also widely used in our daily life. Such equipment, especially on construction sites, is mainly used to cut steel bars. Under normal circumstances, special staff will be arranged to take care of it. If there are more steel pipes to be processed , it is necessary to arrange special personnel to work.

If there are more requirements for steel bars, the operation of the straightener may be overloaded under such circumstances. If the equipment is turned on for 274 hours, the equipment will definitely not be able to accept it. Therefore, during the normal operation, when the staff rests The machine also needs to be buffered.