The Operation Steps Of The Straightening Machine

⒈ Before starting the machine, check whether the hydraulic oil of the hydraulic station, the gear oil of the reduction box and the gear box of the transmission box are full.

⒉ Before starting the main motor, check and adjust the angle of rotation and adjust the working pressure of the hydraulic system.

⒊Inject lubricating oil into each lubricating point, and check the operation of the mechanical transmission part to make it flexible in transportation.

⒋ Operators should wear protective equipment and must not leave their posts or join posts after starting the machine.

⒌After the oil temperature and oil pressure of the hydraulic station are stable, the upper straightening roller is lifted to the initial position.

⒍ Manually receiving the material, the steel pipe is sent to the third pair of straightening rollers, and then the upper straightening roller is pressed down and clamped.

⒎Start the main motor, the steel pipe rotates forward and straightens at the same time.

⒏The motor stops, the straightening roller stops straightening, the upper straightening roller is lifted, and the straightened steel pipe is sent out.

⒐If you need to reverse straightening, you can reverse the main machine through the reversing knob on the operating table to perform reverse straightening.

⒑The main motor stops, the straightening roller stops straightening, the steel pipe is returned to the starting position, and the next straightening program command is to be repeated.

⒒After shutdown, turn off the main power supply and do not change the program controller at will.