How To Use The Steel Bar Straightening Machine Accurately:

 1. According to the diameter of the steel bar of the straightening machine, select the appropriate straightening block, pulling wheel groove and transmission speed. The diameter of the straightening block should be 2-5mm larger than the diameter of the steel bar, and the groove width of the traction sheave should be the same as the diameter of the straightened steel bar.

Second, the adjustment of the straightening block. There are five straightening blocks in the usual straightening cylinder. The first and fifth straightening blocks must be placed on the center line, and the three can be deviated from the line. First make the steel bar offset by an offset of about 3mm, and through debugging, if the steel bar still bends slowly, gradually increase the offset until the straightening stops.

3. After cutting three or four steel bars, it is necessary to stop the machine to check whether the length is appropriate. If there is an error, adjust the limit switch or the fixed-length plate until it stops properly.

4. A steel bar about 1 meter should be installed at the front of the guide tube. The straightened steel bars should pass through the steel pipe first, and then pass through the guide cylinder and the straightening cylinder, so as to avoid the ejection of each plate of steel bars near the end of straightening and hurting people.

5. Before the straightening block is fixed and the protective cover is not covered, do not penetrate the steel bar to avoid the straightening block flying out and hurting people after starting the machine.

6. It is not allowed to stack objects on the machine to avoid mechanical vibration objects falling into the body. The steel bars are loaded into the pressing roller, and the hand and the roller should maintain a certain distance. The roller should not be adjusted during machine operation, and it is forbidden to wear gloves to operate.